HOOKII Neomow X
3D LiDAR SLAM fused with vision replaces both the boundary wire and the RTK base station most competitors still require. The mower documents lift/tilt monitoring and an emergency stop, but slope limits and drive layout are not published, leaving envelope questions open.

Will the HOOKII Neomow X work on your yard?
Describe your yard using the controls. Each choice reads the spec sheet for you, flagging where the HOOKII Neomow X is built for your space and where it isn’t.
A classification of fit for the conditions you set, not a recommendation. Verdicts describe engineering design intent, not test results.
Living with it.
HOOKII documents unusually complete upkeep guidance; independent longevity evidence remains two review periods deep.
Unprovenowner-reported arc
The official support center publishes a 3 to 6 week blade interval, contact-cleaning and winterization procedures, and troubleshooting for blade-motor overtemperature, charging faults, and rain-sensor failures. Two editorial reviews report successful operation; no owner forum or longitudinal record was located.
Rinse the assembly and surrounding areas with clean water once the mower is powered off; HOOKII documents this after each mowing task to keep the disc from jamming.
Replace all five and their screws as a set; HOOKII recommends fresh blades every 3 to 6 weeks, sooner with visible wear, and sells a 10-blade set (two changes) for $29.
Inspect the charging station and rear mower and clean them to bright metal; HOOKII suggests checking every two weeks during peak season.
Fully recharge the at least once every six months whenever the mower sits in extended storage.
Winterize per HOOKII's guide: fully charge, power off, clean, disconnect the charging station, and store flat between -20 and 45 C.
Deep-clean the guard underside with a low-pressure hose at the 30mm blade height per the blade module guide; never a pressure washer or solvents.
Wipe the exterior with a soft brush or damp cloth; alcohol, gasoline, and acetone damage the housing.
$2,599 to buy, then about $100 a year for the replaceable parts below. Over three years that is roughly $300 past the sticker price. Excludes electricity and any repairs.
Replacement cadence from the maintenance schedule; prices shown where the source documents them. Part links may earn a commission and do not influence the classification.
-
CautionBlade-stop timing unpublishedHOOKII documents lift and tilt monitoring and an emergency stop; no blade-stop timing figure is published.
-
CautionPower off before flippingBlade maintenance requires full power-off and waiting for the disc to stop before tilting the mower.
-
CautionStore the battery near 25 C and never above 60 C, away from flames.
-
Slope envelope unpublishedMaximum slope is not published, so sloped-yard owners cannot verify the rated envelope.
The full spec sheet.
Priced above the category median, with every figure charted against the category below.
- FootprintThe width, depth and height of the robot itself, without its dock.
- 20 × 28.7 in · 13.3 in tall•
- WeightThe robot alone, without its dock, as the maker states it.
- 37.7 lbs•
- Cutting width
- 11 in•
- Cutting height range
- 1.2-3.3 in•
- Boundary method
- Wire-free, 3D LiDAR SLAM with vision•
- Blade system
- 5 blades on a cutting disc✓
3D LiDAR SLAM fused with a vision system; no boundary wire, RTK base station, or satellite positioning required (manufacturer)
Position shows where the figure sits across the tracked category, not a quality judgment.
How the assessment has moved.
Every announcement, release and reassessment behind the current classification.
-
Sep 2026 · AssessmentAutonomy Ladder reclassified III → IV
-
Aug 2026 · AssessmentReadiness reassessed: Promising Progress → Ready Now
-
Aug 2026 · AssessmentRobovations Score recorded at 54 of 100
-
May 2025 · ReleaseHOOKII completes Neomow X Kickstarter, launches it globally in May 2025
-
Jun 2024 · AnnouncementHOOKII debuts Neomow X at Spoga-Gafa 2024, wins Plus X Award
-
Aug 2023 · AnnouncementHOOKII launches Neomow X on Kickstarter, quickly clears its funding goal
What people actually ask.
OperationDoes the Neomow X need a boundary wire or an RTK base station?
OperationWhat is the maximum slope the Neomow X can mow?
OperationHow does the Neomow X handle small obstacles like sprinkler heads?
OperationIs there a smaller or larger version of the Neomow X?
OperationDoes the mower stop the blade if it is lifted or tilted?
Reference the HOOKII Neomow X classification.
Embed the Autonomy Ladder™ mark or copy the citation. The mark is served from this record, so a reassessment updates it on your page automatically.
Get the embed code and citation
Scale proportionally only, up to 2× (536px wide)(224px wide). No recolouring, cropping, rotating, or re-typesetting.
Robovations. "HOOKII Neomow X: Autonomy Level IV (Environmental Autonomy)." Autonomy Ladder™, assessed September 2026. https://robovations.com/robots/hookii-neomow-x/
- Link it. The mark must point at this record. An unlinked mark is not authorised.
- Hot-link it. Never download, self-host, or re-upload the image. A saved copy stops updating, and a mark that has stopped updating is a claim we no longer stand behind.
- A classification, not an endorsement. It may not appear beside language implying Robovations recommends, rates, or approves the product.



