Skip to content
Saved
RELEASED 2025.02REASSESSED 2026.08.30Compare
Beatbot

Beatbot AquaSense 2

The successor to the original AquaSense brings improved mapping logic and cordless operation to mid-range pool maintenance. Battery endurance and climb capacity remain category-typical; the payoff is one less robot variant in a product line.

Beatbot AquaSense 2
FIT CHECK

Will the Beatbot AquaSense 2 work in your pool?

Describe your pool using the controls. Each choice reads the spec sheet for you, flagging where the Beatbot AquaSense 2 is built for your space and where it isn’t.

Pool type

Pool size

Debris load

Coverage you want

A classification of fit for the conditions you set, not a recommendation. Verdicts describe engineering design intent, not test results.

OWNERSHIP

Living with it.

Cordless redesign introduces new stress points; firmware iterations expected.

Unprovenowner-reported arc

The record so far

Cordless motor and battery present new durability unknowns. Owner reports over next 6 months will clarify dock reliability and waterline-motor longevity.

What goes wrongnot yet documented independently

The independent record is still forming. Failure modes are listed once an outside source reports them.

Upkeep routine
Each useEvery cycle

Lift out the 2 L filter basket and rinse the debris off with fresh water.

Weekly52×/yr

Inspect the waterline brush and the drive tracks for trapped grit, hair or wear.

Monthly12×/yr

Deep-clean the basket and check that the 150 micrometer media is not torn or distorted.

Seasonal4×/yr

In freezing climates, take the robot out of the pool and store it and the charging stand indoors; dry all seals before storage.

As neededno fixed schedule

Charge on the vertical stand on a hard, non-combustible surface clear of anything that can burn. Beatbot gives about four hours for a full charge of the 10,000 mAh pack.

Confirm app connectivity before scheduled cycles; install firmware updates when Beatbot releases them.

Cost over timeabout $240 past the sticker over three years
PurchaseRunning cost
Year 1
$1,378
Year 3

$1,538
Year 5

$1,698

$1,298 to buy, then about $80 a year in replaceable parts. Over three years that is roughly $240 past the sticker price. Excludes electricity and any repairs.

Safety notes1 caution · 1 note
  • CautionNo emergency buoyancyUnit sinks if battery dies mid-pool; manual retrieval required.
  • Floating obstacle collision riskCannot detect floating deck chairs, inflatables, or loose cover straps.
SPECIFICATION

The full spec sheet.

Priced near the category median, with every figure charted against the category below.

17.8 in17.1 in9.2 inDimensional drawing
Key specificationsManufacturer-published
FootprintThe width, depth and height of the robot itself, without its dock.
17.1 × 17.8 in · 9.2 in tall•
WeightThe robot alone, without its dock, as the maker states it.
23.1 lbs•
Wi-FiThe bands the robot can join; many models need a 2.4 GHz network to set up.
Supported✓
Max pool area
3,230 sq ft•
Cycle length
240 min✓
Surfaces cleaned
Floor, walls, waterline✓
Power type
Cordless battery✓
Filter capacity
2 L•
FilterA pleated filter between the bin and the fan; it loses airflow long before it looks dirty.
150 micron•
Mapping & navigation

Smart mapping with obstacle avoidance

Where it lands · ranked across 75 robot pool cleanersThis robotMedianTypical range
RuntimeThe maker's stated running time on one charge, at a standard setting.240min
90 min1,800 min
Bottom of range
PriceThe maker's list price, not a price found in a shop.$1,298

$299$4,250
Near median
Charge timeTime from empty to full on the dock, as the maker states it.240min

150 min480 min
Near median
WeightThe robot alone, without its dock, as the maker states it.23.1lbs

7.9 lbs46.3 lbs
Near median

Position shows where the figure sits across the tracked category, not a quality judgment.

Official referencesProduct page
RECORD

How the assessment has moved.

Every announcement, release and reassessment behind the current classification.

Coming soon
Just launched
Active updates
Settled
Discontinued
  1. Sep 2026 · AssessmentRobovations Score revised 48 → 51
  2. Sep 2026 · AssessmentRecord status: Provisional → Pending
  3. Aug 2026 · AssessmentReadiness reassessed: Promising Progress → Known Issues
  4. Aug 2026 · AssessmentRobovations Score rescored under v4.2: 67 → 48
  5. Jul 2026 · AssessmentRobovations Score recorded at 67 of 100
Editorial comparisons

How Beatbot AquaSense 2 compares.

All comparisons →
Common questions

What people actually ask.

5 answered
OwnershipDoes the AquaSense 2 waterline brush reach above the pool surface?
No. The brush works at the waterline itself, applying Beatbot’s dual-pass scrub to the band it can reach; algae standing above the water still needs hand work. Owner reports describe good results on tile and concrete at the line.
OperationCan I use the AquaSense 2 with a pool cover partially on?
No. The robot needs open water to surface-park at the end of a cycle and to be recalled from the app, and a cover left partly on can trap it below. Take the cover fully off before a run. Charging is unaffected either way, because the charging stand lives on dry land.
OwnershipWhat filter maintenance does Beatbot specify?
The AquaSense 2 filters through a 2 L basket rated to 150 micrometers, not a disposable foam cartridge. Rinse it out after each run and deep-clean it periodically. Beatbot publishes no replacement interval or replacement price for it.
ComparisonHow does the AquaSense 2 handle plaster versus vinyl liners?
Compatible with both. Owner reports confirm vinyl liners tolerate brush pressure well. Rough plaster may shed debris into the filter more aggressively.
OperationIf the battery runs low mid-cycle, does the robot come back on its own?
Yes, and to the surface rather than to a dock. Surface parking is the feature this model is named for: when the cycle finishes or the battery runs low, the robot drives itself up to the water surface and waits at the edge instead of settling on the floor. It can also be recalled to the surface from the app at any time, and SmartDrain empties the water out of it first so the lift is lighter.

Availability

Where it's sold

We may earn commission from qualifying purchases. This does not influence classification.

Cite & Embed

Reference the Beatbot AquaSense 2 classification.

Embed the Autonomy Ladder™ mark or copy the citation. The mark is served from this record, so a reassessment updates it on your page automatically.

Get the embed code and citation
124161
268112
Clear space 3222 on all sides
Embed code

Scale proportionally only, up to 2× (536px wide)(224px wide). No recolouring, cropping, rotating, or re-typesetting.

Citation

Robovations. "Beatbot AquaSense 2: Autonomy Level III (Conditional Autonomy)." Autonomy Ladder™, assessed August 2026. https://robovations.com/robots/beatbot-aquasense-2/

  • Link it. The mark must point at this record. An unlinked mark is not authorised.
  • Hot-link it. Never download, self-host, or re-upload the image. A saved copy stops updating, and a mark that has stopped updating is a claim we no longer stand behind.
  • A classification, not an endorsement. It may not appear beside language implying Robovations recommends, rates, or approves the product.
Where to next

Three ways to keep going.

For browsers

See every Level III.

Every robot we’ve classified at conditional autonomy. Sorted by readiness, score, and price. Filter by category, manufacturer, or release date.

Updated weekly with new entries and reclassifications.