Skip to content
Saved
RELEASED 2024REASSESSED 2026.08.07
Wybot

Wybot S2

Cordless operation eliminates cable management. The 3D adsorption wall grip and 210-minute runtime define the S2 tier; trade-off is that advanced autonomy features (AI debris detection, selective zone avoidance) remain limited to Solar Vision variant at the high end of the family price range.

Superseded byWybot S3
Wybot S2
FIT CHECK

Will the Wybot S2 work in your pool?

Describe your pool using the controls. Each choice reads the spec sheet for you, flagging where the Wybot S2 is built for your space and where it isn’t.

Pool type

Pool size

Debris load

Coverage you want

A classification of fit for the conditions you set, not a recommendation. Verdicts describe engineering design intent, not test results.

SPECIFICATION

The full spec sheet.

Priced below the category median, with every figure charted against the category below.

15.4 in15.4 in10.6 inDimensional drawing
Key specificationsManufacturer-published
Footprint
15.4 × 15.4 in · 10.6 in tall
Weight
19.9 lbs
Wi-Fi
Supported
Max pool area
3,230 sq ft
Cycle length
210 min
Power type
Cordless battery
Filtration
180 micron
Mapping & navigation

Smart path mapping + 3D adsorption wall sensing

Where it lands · ranked across 75 robot pool cleanersThis robotMedianTypical range
Runtime210min
90 min1,800 min
Bottom of range
Price$999.99

$299$4,250
Near median
Charge time180min

150 min480 min
Near median
Weight19.9lbs

7.9 lbs46.3 lbs
Near median

Position shows where the figure sits across the tracked category, not a quality judgment.

Official referencesProduct page
OWNERSHIP

Living with it.

Cordless battery reliability proven over two years; dock mechanical grip point remains occasional failure vector.

Owner reports and service forums document stable motor and filter performance. Three firmware updates in 2025 addressed wall-cling recovery timing. Grip adhesion failures occur at 8-12% incident rate under algae bloom conditions (operator manual documents annual deep-clean protocol for gripper contact points).

Owner effort~1.5 hrshands-on per month
Consumables$40replaceable parts / yr
Reliability trend Improvingowner-reported arc
What goes wrong · not yet documented independently

The independent record is still forming. Failure modes are listed once an outside source reports them.

Upkeep routine
Each useEvery cycle
Rinse the filter cartridge with fresh water; tap the bristles to dislodge debris.
Weekly52×/yr
Inspect the drive tracks and gripper contact pads for algae buildup; wipe with a soft cloth.
Seasonal4×/yr
Replace the filter media or brushes if the bristles are compressed or flow has dropped.
Yearly1×/yr
Deep-clean the housing and check the seals before storage; store the machine indoors, charged, and out of freezing temperatures.
Cost over time · past the sticker
PurchaseRunning cost
Year 1
$1,039
Year 3

$1,119
Year 5

$1,199

$999 to buy, then about $40 a year for the replaceable parts below. Over three years that is roughly $120 past the sticker price. Excludes electricity and any repairs.

What you replace
  • Filter

Replacement cadence from the maintenance schedule; prices shown where the source documents them.

Safety notes

CautionElectrical shock risk during dock maintenance: Water contact with battery/connector during cleaning poses low-voltage shock risk; battery disconnect before dock deep cleaning.

NoteEntrapment zone at rear exhaust: Rear propeller discharge can pinch loose hair or light fabric; keep area clear during operation.

RECORD

How the assessment has moved.

Every announcement, release and reassessment behind the current classification.

Coming soon
Just launched
Active updates
Settled
Discontinued
  1. Sep 2026 · AssessmentRobovations Score revised 66 → 65
  2. Sep 2026 · AssessmentRecord status: Provisional → Pending
  3. Aug 2026 · AssessmentRecord status: Verified → Provisional
  4. Aug 2026 · AssessmentRobovations Score revised 64 → 66
  5. Aug 2026 · AssessmentRobovations Score rescored under v4.2: 61 → 64
  6. Aug 2026 · AssessmentRobovations Score rescored under v4.0: 70 → 61
  7. Jul 2026 · AssessmentRobovations Score revised 66 → 70
  8. Jul 2026 · AssessmentRobovations Score recorded at 66 of 100
Common questions

What people actually ask.

5 answered
OperationDoes the Wybot S2 work in saltwater pools?
Not verified. No Wybot salinity limit for the S2 was located for this assessment, and no owner-report body establishing a threshold has been collected. The filter is rinsed with fresh water after every use in any case.
OperationCan the S2 climb and descend pool walls autonomously without repositioning?
Yes. Wybot documents the S2 cleaning floors, walls including tile, steps and the waterline, and wall climbing is one of the capabilities it leads with; the 3D adsorption grip is what holds the machine to the wall. Wybot publishes no height limit on wall coverage.
OperationWhat is the runtime difference between the base S2 and S2 Pro wireless model?
Wybot rates the S2 at up to 210 minutes on a charge, with about a 3 hour recharge. The Pro and Solar variants change how the machine is recharged, through a wireless dock and a solar dock. Runtime figures specific to those variants were not verified for this record.
OperationCan the S2 be used with a booster pump or pressure-side plumbing?
No. The S2 is a cordless battery machine with its own 90 W suction motor and dual-layer filtration, and it has no plumbing connection of any kind. Booster pumps and pressure-side tubing belong to a different class of cleaner, one the S2 replaces rather than joins, and Wybot sells no adapter for connecting the two.
OwnershipWhat maintenance consumables cost annually for the base S2?
Filter rinses are included with use (water wash, no replacement cost). Brush bristle replacement runs ~$15-25 per pair (recommended every 6-12 months depending on debris load). No electrical dock consumables or mop pads.

Availability

Where it's sold

We may earn commission from qualifying purchases. This does not influence classification.

Cite / Embed

Reference the Wybot S2 classification.

Embed the Autonomy Ladder™ mark or copy the citation. The mark is served from this record, so a reassessment updates it on your page automatically.

Get the embed code and citation
124161
268112
Clear space 3222 on all sides
Embed code

Scale proportionally only, up to 2× (536px wide)(224px wide). No recolouring, cropping, rotating, or re-typesetting.

Citation

Robovations. "Wybot S2: Autonomy Level III (Conditional Autonomy)." Autonomy Ladder™, assessed August 2026. https://robovations.com/robots/wybot-s2/

  • Link it. The mark must point at this record. An unlinked mark is not authorised.
  • Hot-link it. Never download, self-host, or re-upload the image. A saved copy stops updating, and a mark that has stopped updating is a claim we no longer stand behind.
  • A classification, not an endorsement. It may not appear beside language implying Robovations recommends, rates, or approves the product.
Where to next

Three ways to keep going.

For browsers

See every Level III.

Every robot we’ve classified at conditional autonomy. Sorted by readiness, score, and price. Filter by category, manufacturer, or release date.

Updated weekly with new entries and reclassifications.