Mamibot iGLASSBOT W168
The W168 is the square-body iGLASSBOT brought up to dual water spraying, which is the change that matters: the W120 generation needed the cloth pre-wetting by hand. The safety story is the other half of it, a 500 mAh UPS rated to 30 minutes of suction after a power cut, plus an alarm and a rope. What it still cannot do is move itself between panes, which is the ceiling on every window robot in this class.

Will the Mamibot iGLASSBOT W168 work on your windows?
Describe your windows using the controls. Each choice reads the spec sheet for you, flagging where the Mamibot iGLASSBOT W168 is built for your space and where it isn’t.
A classification of fit for the conditions you set, not a recommendation. Verdicts describe engineering design intent, not test results.
Living with it.
A simple corded machine; cloth condition and ring seal decide whether any run finishes.
Unprovenowner-reported arc
Mamibot's manual traces most stoppages to owner-correctable causes: air leaks from unseated rings or cloths, clogged spray nozzles, slippery worn cloths. Third-party owner reporting on the W168 is thin since its late-2024 release; the corded, rope-tethered design leaves little unattended failure surface.
The independent record is still forming. Failure modes are listed once an outside source reports them.
Wash both microfiber cleaning cloths and let them dry fully; six cloths ship in the box, so a dry set is always ready.
Empty the 80 ml water tank, wipe the body down with a soft dry towel, and check the safety rope and extension cable for wear.
Recharge the backup battery during storage; Mamibot specifies a full charge (about 2.5 hours) at least every 3 months to prevent deep-discharge.
Swap in a dry cloth mid-job if the robot slips or streaks; replace worn-out cloths, which Mamibot classes as wear items with no published replacement interval.
Clear the two spray nozzles with the supplied cotton swabs when spraying stops on a full tank; a nozzle that will not clear needs replacing.
Re-seat the two cleaning rings and cloths if the alarm signals an air leak; the teeth on the body must sit in the ring slots.
Tighten the rotating-plate screws if movement turns rough or uneven.
-
CautionFall risk at heightAnchor the safety rope to an indoor fixture every run; cordon the area below exterior windows.
-
CautionUnsuitable glass typesMamibot warns against cracked, uneven, or frameless glass; suction loss on these surfaces drops the robot.
-
No empty-tank alertNothing signals a dry 80 ml tank; watch the spray and refill mid-session.
-
Corded operation onlyRuns tethered to mains; the 500 mAh backup holds suction about 30 minutes after power loss.
The full spec sheet.
Manufacturer-published figures, measured against every robot window cleaner we track.
- FootprintThe width, depth and height of the robot itself, without its dock.
- 5.6 × 11.5 in · 3.4 in tall•
- WeightThe robot alone, without its dock, as the maker states it.
- 2.4 lbs•
- BatteryStored energy in watt-hours; a larger pack runs longer, not harder.
- 7 Wh · Li-ion•
- Suction modes
- 2,000-3,000 Pa✓
- Rated power
- 72 W at 24 V✓
- Motor speed
- 30,500 rpm✓
- Water tankThe clean-water tank that feeds the mop, on the robot or in the dock.
- 80 mL, automatic or manual spray✓
- Extension cord
- 5 m✓
- Cleaning modes
- 3, with return to start point✓
- Backup battery runtime
- 30 min•
- Min pane size
- 11.8 in•
Route-planned stripe patterns across three selectable modes, with edge detection and a return to the start point. No mapping and no pane recognition.
Position shows where the figure sits across the tracked category, not a quality judgment. The vacuum holding the robot on the glass, not cleaning power. The figure has no standard test method, so it is comparable only within a brand and generation.
What people actually ask.
OperationWhat is new in the W168 compared to the W120-T?
OperationWhat happens if the power fails while it is on the glass?
ComparisonCan it clean more than one window on its own?
Reference the Mamibot iGLASSBOT W168 classification.
Embed the Autonomy Ladder™ mark or copy the citation. The mark is served from this record, so a reassessment updates it on your page automatically.
Get the embed code and citation
Scale proportionally only, up to 2× (536px wide)(224px wide). No recolouring, cropping, rotating, or re-typesetting.
Robovations. "Mamibot iGLASSBOT W168: Autonomy Level II (Assisted Autonomy)." Autonomy Ladder™, assessed September 2026. https://robovations.com/robots/mamibot-iglassbot-w168/
- Link it. The mark must point at this record. An unlinked mark is not authorised.
- Hot-link it. Never download, self-host, or re-upload the image. A saved copy stops updating, and a mark that has stopped updating is a claim we no longer stand behind.
- A classification, not an endorsement. It may not appear beside language implying Robovations recommends, rates, or approves the product.




