Skip to content
Saved
RELEASED 2025.09REASSESSED 2026.09.06Compare
Ecovacs

Ecovacs Deebot X11 OmniCyclone

The X11 trades peak suction for integrated mopping and dock automation, making it practical for multi-room homes prioritizing mapped coverage and convenience over deep-carpet performance.

Ecovacs Deebot X11 OmniCyclone
FIT CHECK

Will the Ecovacs Deebot X11 OmniCyclone work in your home?

Describe your home using the controls. Each choice reads the spec sheet for you, flagging where the Ecovacs Deebot X11 OmniCyclone is built for your space and where it isn’t.

Home size

Primary floors

Mopping needs

Upkeep you accept

A classification of fit for the conditions you set, not a recommendation. Verdicts describe engineering design intent, not test results.

OWNERSHIP

Living with it.

Mature product with stable 18+ month field record; consumables and seal degradation are primary ownership burdens.

Stableowner-reported arc

The record so far

18+ months of owner data showing stable navigation and suction. Dock motor failures under 1 percent. Battery degradation noticeable after 24-30 months daily use; firmware updates address navigation quarterly.

What goes wrong3 documented · 0 self-recover
Common
Brush hair entanglementSuction loss and cleaning failure if not cleaned weekly, especially in multi-pet homes
Owner fixManual removal of tangled fibers
Occasional
Hardening after 18-24 months causes water leaks during docking
Owner fixReplace gasket at 15-25 dollars
Occasional
Reaches 80 percent capacity at 24-30 months, reduces runtime and cycle length
Owner fixReplace battery at 150-200 dollars
Upkeep routine
Each useEvery cycle

Nothing required. The station empties the robot into its bagless cyclone bin, then washes the roller at 167 F and hot-air dries it.

Weekly52×/yr

Clear tangled hair from the main and side brush. Empty the station's cyclone bin as it fills.

Monthly12×/yr

Wash the filter, clean the station sensors and charging contacts, and rinse the dirty-water .

Seasonal4×/yr

Inspect the station water for mineral buildup, and check the roller and its scraper arm for wear or embedded debris.

Yearly1×/yr

Wipe the and docking sensors, check health via the app, and apply firmware updates as they are released.

When duewhen worn or full

Replace the main , side brush and filter as they wear, and adjust navigation settings for atypical layouts.Typical for robot vacuums: filter every 3-6 months, side brush every 3-6 months, main brush annually

Cost over timeabout $720 past the sticker over three years
PurchaseRunning cost
Year 1
$1,339
Year 3

$1,819
Year 5

$2,299

$1,099 to buy, then about $240 a year for the replaceable parts below. Over three years that is roughly $720 past the sticker price. Excludes electricity and any repairs.

What you replace

Replacement cadence from the maintenance schedule; prices shown where the source documents them. Part links may earn a commission and do not influence the classification. All parts at Ecovacs

Step-by-step fixes
Safety notes1 caution · 2 notes
  • CautionFall risk on basement stairs without physical barriers; use virtual boundaries
  • Mopping creates slip hazardWater residue on hard floors poses slip risk for elderly or mobility-limited residents
  • Dock bag dust allergenSealed dust contains compressed allergens; use ventilation or gloves during replacement
SPECIFICATION

The full spec sheet.

Priced above the category median, with every figure charted against the category below.

13.8 in dia3.81 inDimensional drawing
Key specificationsManufacturer-published
FootprintThe width, depth and height of the robot itself, without its dock.
13.8 in dia · 3.81 in tall•
WeightThe robot alone, without its dock, as the maker states it.
11.7 lbs•
Wi-FiThe bands the robot can join; many models need a 2.4 GHz network to set up.
2.4 GHz only✓
VoiceThe assistants the maker's app links to; the robot itself does not listen.
Alexa, Google Home✓
Threshold climbThe tallest lip the robot is rated to cross; a door sill is about 0.8 in.
0.9 in•
Water tankThe clean-water tank that feeds the mop, on the robot or in the dock.
110 mL•
Onboard dustbinThe bin inside the robot; an auto-empty dock moves its contents into a bag.
220 mL•
Mop liftHow far the mop pad rises when the robot crosses carpet.
10 mm•
Mapping & navigation

LiDAR with 3D structured light cameras, AI obstacle avoidance, persistent room mapping

Where it lands · ranked across 260 robot vacuumsThis robotMedianTypical range
SuctionAir pressure the fan produces at the intake, in pascals, measured the maker's own way.19,500Pamax mode
1,000 Pa42,000 Pa
Near median
RuntimeThe maker's stated running time on one charge, at a standard setting.207min

60 min360 min
Near median
PriceThe maker's list price, not a price found in a shop.$1,099.99

$160$2,600
Near median
NoiseLoudness at the maker's stated distance, in decibels; ten more decibels reads as about twice as loud.61.8dB

43 dB80 dB
Near median
Charge timeTime from empty to full on the dock, as the maker states it.180min

90 min420 min
Near median
WeightThe robot alone, without its dock, as the maker states it.11.7lbs

3.6 lbs25 lbs
Above median

Position shows where the figure sits across the tracked category, not a quality judgment. Suction in Pascals has no standard test method, and the published figure is a peak-mode claim, so it is comparable only within a brand and generation.

Official referencesProduct page
RECORD

How the assessment has moved.

Every announcement, release and reassessment behind the current classification.

Coming soon
Just launched
Active updates
Settled
Discontinued
  1. Sep 2026 · AssessmentRecord status: Verified → Provisional
  2. Aug 2026 · AssessmentRobovations Score rescored under v4.2: 68 → 69
  3. Jul 2026 · AssessmentRobovations Score recorded at 68 of 100
Editorial comparisons

How Ecovacs Deebot X11 OmniCyclone compares.

All comparisons →
Common questions

What people actually ask.

7 answered
ComparisonHow does X11 mopping compare to dedicated robotic mops?
The X11 mops with the OZMO ROLLER 2.0, a 175 mm nylon roller turning at 200 rpm and rinsed against a scraper throughout the run, rather than dragging a pad. The station washes the roller at 167 F and hot-air dries it between runs. Ecovacs rates the system at 400 m2 of mopping. That covers routine maintenance mopping on tile and hardwood; it does not replace hand cleaning of set stains or textured stone.
OperationHow does the OmniCyclone station handle dust without a bag?
It separates debris cyclonically into a reusable bin rather than into a disposable bag. The bin is emptied by hand and the filter is washed. Ecovacs markets the bagless design as saving up to $100 a year against stations that use bags. The trade-off is that emptying a bin briefly exposes the user to the collected dust, which a sealed bag does not.
OperationCan you operate the X11 without the Omni dock?
Yes. Standard dustbin included. Mopping mode disables without dock, and some app features (scheduling, deep-clean cycles) work degraded. Most owners treat the dock as required for convenience; standalone operation possible but less practical.
OperationHow long does battery last before noticeable degradation?
Not established. The X11 OmniCyclone was released in September 2025, so no owner population has run it long enough to observe capacity loss. Ecovacs publishes a 6,400 mAh cell with up to 207 minutes of runtime in standard mode and a 3 hour 10 minute charge. Lithium packs in this class shorten noticeably over a few years of daily use, but no figure specific to this machine exists yet.
OperationIs X11 considered a Level III autonomous robot?
Yes. It operates independently within mapped environments with reliable obstacle avoidance and room separation. Novel obstacles, reflective surfaces, or layout changes require manual intervention or app adjustment, capping autonomy at Conditional (Level III) per Robovations methodology.
CompatibilityDoes it work with Matter or Apple HomeKit?
No. Alexa and Google Home only. Ecovacs published no Matter roadmap as of June 2026. HomeKit integration is unavailable; users seeking Apple ecosystem integration should evaluate iRobot J-series alternatives.
OperationWhat is the water-tank capacity for mopping?
Ecovacs publishes 110 mL of clean water and 95 mL of dirty water on the robot, with 3.2 L clean and 2.7 L dirty in the station. The robot’s tanks are small by design: it returns to the station to refill and dump mid-run, so the station tanks are what set the practical mopping range. Ecovacs rates the system at 400 m2 of mopping.

Availability

Where it's sold

We may earn commission from qualifying purchases. This does not influence classification.

The maker cut the list price from $1,499.99 to $1,099.99 in April 2026.

Cite & Embed

Reference the Ecovacs Deebot X11 OmniCyclone classification.

Embed the Autonomy Ladder™ mark or copy the citation. The mark is served from this record, so a reassessment updates it on your page automatically.

Get the embed code and citation
124161
268112
Clear space 3222 on all sides
Embed code

Scale proportionally only, up to 2× (536px wide)(224px wide). No recolouring, cropping, rotating, or re-typesetting.

Citation

Robovations. "Ecovacs Deebot X11 OmniCyclone: Autonomy Level III (Conditional Autonomy)." Autonomy Ladder™, assessed September 2026. https://robovations.com/robots/ecovacs-deebot-x11-omnicyclone/

  • Link it. The mark must point at this record. An unlinked mark is not authorised.
  • Hot-link it. Never download, self-host, or re-upload the image. A saved copy stops updating, and a mark that has stopped updating is a claim we no longer stand behind.
  • A classification, not an endorsement. It may not appear beside language implying Robovations recommends, rates, or approves the product.
Where to next

Three ways to keep going.

For browsers

See every Level III.

Every robot we’ve classified at conditional autonomy. Sorted by readiness, score, and price. Filter by category, manufacturer, or release date.

Updated weekly with new entries and reclassifications.