Dreame L10 Pro · Ecovacs Deebot T50 Pro Omni

The L10 Pro adds 3D obstacle avoidance the D9 does not have, and rated suction rises from 3,000 Pa to 4,000 Pa. Mopping hardware is unchanged: the same flat pad, no lift, no dock washing.

The premium over the D9 buys obstacle avoidance and a third more rated suction. It buys nothing on the mop side; the pad, the 270 ml tank and the manual rinse are identical.

The 81 mm body trades onboard capacity for clearance: the robot carries 55 ml of water, so a long mopping run is broken up by returns to the station, which holds 4 L clean and 4 L dirty.

The station’s dry cycle runs two to four hours at 45C after a mopping run, so the dock is still working well after the robot has finished and parked.

High-pile carpet or homes with extensive area rugs

There is no mop lift, so the pad and tank have to be taken off before a run that crosses rugs. Owner reports document reduced pickup on shag and deep pile.

Multi-story homes requiring cross-floor consistency

Moving between floors means carrying the robot and relocating the dock by hand on this generation, as with the D9. The added obstacle sensor changes nothing about that.

Owners prioritizing autonomous mopping over vacuuming

The pad wets the floor as the robot vacuums, but everything around it is manual: fill the 270 ml tank, fit the pad, rinse it afterward. There is no mop lift, no dock washing and no pad drying.

Homes without a permanent spot for the station

The Omni station carries 4 L of clean water, 4 L of dirty water and a 3 L dust bag, and needs a fixed position against a wall near an outlet. Where that space does not exist, most of what this model is sold on cannot be used.

Homes with high-pile surfaces as primary flooring

Suction is 15,000 Pa and Ecovacs' documentation for the machine centers on hard floors and edge work. Pickup on pile is a function of suction, brush agitation and floor contact, none of which a filter change or a firmware update alters.