Maytronics Dolphin Escape · Wybot C2

The cycle is fixed and the route belongs to the machine. CleverClean scans the floor for a fixed 1.5 hours with no map to inspect and no way to send it back to a missed area short of running the cycle again.

No camera, no mapping: seven preset modes replace a perception system, so coverage quality tracks the mode the owner selects, not the robot’s own judgment.

The added 10-micron filter stage catches finer sediment than a single-basket cleaner, but a three-hour charge against a three-hour runtime still caps use at one cycle per half day.

At 17.6 lb wet, the machine that documents step and slope coverage is also the one an owner has to physically lift out every time.

Skipping the AI camera keeps the price roughly $200 below the C2 Vision, and gives up debris-adaptive path planning to do it.

Pools that need the walls and waterline cleaned

The Escape is a floor cleaner and does not climb walls or work the waterline. Surface and installation are not constraints: Maytronics rates it for vinyl, fiberglass and gunite, in-ground and above-ground alike.

Pools with heavy waterline algae or mineral deposits

Floor-only coverage leaves waterline untouched. Calcium and algae stains require manual brushing; Escape cannot address them autonomously.

Pools longer than 33 ft

Maytronics rates the Escape for pools up to 33 ft, and the 40 ft cable sets the practical reach. Length and cable run are the limits, not water volume.

Owners with hands-off scheduling expectations

Maytronics lists no timer, Wi-Fi or remote control for the Escape, so it cannot start itself. Every cycle means uncoiling the cable, placing the unit in the pool, switching the power supply on and lifting it back out afterward.

Pools larger than the 2,152 sq ft rated coverage

Wybot rates the C2 by area, up to 2,152 sq ft, and the machine has no mapping to compensate; larger or irregular pools risk incomplete coverage.

Owners who want the machine to sense and adapt to debris

The plain C2 carries no camera at all; adaptive debris detection and selective zone avoidance are reserved for the C2 Vision, priced roughly $200 higher.

Owners who need back-to-back cleaning cycles without downtime

A roughly three-hour charge against up to three hours of runtime in Eco mode means only one full cleaning cycle fits comfortably in a half day.

Owners who cannot lift a 17.6 lb wet unit from the pool

At 17.6 lb, the C2 is a real lift once it is full of water and pulled from the pool after every cycle, with no self-emptying dock.