
Ecovacs Ultramarine P1 · Wybot C1
All robot pool cleaners. Every measure below is plotted against the full class, so a difference can be read against how much the class itself varies.
- Ecovacs Ultramarine P1
- Wybot C1


Wybot C1
- Autonomy
- IIAssisted Autonomy
- Score
- 64/100 Capable
- Readiness
- Known Issues
- Price
- $569.99list
Up to three
What each one does on its own.
The Autonomy Ladder is the same five rungs for every robot on the site. A rung describes the conditions a robot handles without you, not how good it is.
Where they actually differ.
The Robovations Score is nine inputs across three pillars, each weighted as shown and each scored so that more is better. A robot can lead on one and trail on another, which is the point of showing them apart. Cost of ownership and data handling are reported on each robot's own page and are never averaged into the score.
Capability
- Ecovacs Ultramarine P178
- Wybot C170
- Ecovacs Ultramarine P168
- Wybot C145
- Ecovacs Ultramarine P158
- Wybot C143
- Ecovacs Ultramarine P164
- Wybot C1100
Dependability
- Ecovacs Ultramarine P170
- Wybot C180
- Ecovacs Ultramarine P165
- Wybot C165
- Ecovacs Ultramarine P162
- Wybot C148
Ownership burden
- Ecovacs Ultramarine P152
- Wybot C167
- Ecovacs Ultramarine P172
- Wybot C161
How far apart is a long way?
A number only means something next to the spread it sits in. Each track below is the real range across every classified robot in the class, with the median marked.
- Ecovacs Ultramarine P1$499.99
- Wybot C1$569.99
- Ecovacs Ultramarine P1180 min
- Wybot C1150 min
- Ecovacs Ultramarine P1240 min
- Wybot C1180 min
- Ecovacs Ultramarine P122.3 lbs
- Wybot C117.6 lbs
Not compared, because fewer than two of these robots carry a published figure: Suction, Noise, Height.
What the numbers leave out.
The trade-off
What each design gives up to be good at what it is good at.
No cable to manage, and no way back out of the water without a pole and hook.
Floors came up clean for both reviewers; walls were where results split.
Cordless operation removes the cable and swivel of a tethered cleaner at the cost of a bounded battery cycle: the machine runs up to 150 minutes, parks itself at the wall, and waits to be lifted out and charged rather than drawing power continuously.
Who each one is wrong for
Stated by the record itself. A robot being wrong for a household is a fact about fit, not a fault.
- Owners who want the robot out of the pool on its own
- It parks near the edge when done, but the manual has the owner lift it out with a hook on a pool pole every run.
- Pools where spotless walls matter most
- Digital Reviews found some wall sections cleaned to the waterline while on others the robot detached and drifted back down.
- Pools with sun shelves or shallow steps
- The manual says ledges under 50 cm deep can trap it and that it was not designed to clean steps.
- Owners who want live monitoring during a clean
- The app connects over Bluetooth only above water, so progress cannot be watched once it submerges, per the manual and Digital Reviews.
- Daily back-to-back cleaning cycles
- The manual lists about 4 hours to charge, and EFTM measured 3 hours 40 minutes from 5 percent.
- Pools larger than 1,615 sq ft
- Wybot rates the C1 by surface area, up to 1,615 square feet. Larger pools take more than one cycle per clean, and each cycle ends with the machine coming out of the water to charge.
- Owners wanting a cleaner that lives in the pool
- The C1 runs a scheduled cycle, parks at the wall and comes out to charge. It is not a permanently installed or continuously powered cleaner that stays in the water between cycles.
- Pools under heavy leaf and debris load
- Capacity is bounded by the onboard filter, which is rinsed between cycles. Pools with steady leaf fall need skimming or a larger-capacity cleaner rather than a repeat cycle.
What stays your job
The upkeep ownership hands back to you, whatever the autonomy level says.
- After every use: Lift it out with the pole hook, then rinse the 180-micron basket and 3-micron filter separately.
- After every use: Dry the charging port and recharge for about 4 hours indoors.
- Every 3-6 months: Open the impeller cover and clear debris from the impeller, track and cogs (manual: every 3 to 4 months).
- As needed: Replace the 3-micron filter every 150 hours of use ($24.99 inner basket on Ecovacs’ US store).
- Annually: Check tracks and roller brushes for wear and replace them if worn.
- Seasonally: Store dry and charged, topping up to 40 to 60 percent every three months.
- After every cycle: Remove and rinse the filter with fresh water and clear the intake before the next run. Rinse the machine itself with fresh water after use in a saltwater pool.
- Every charge: Charge the machine out of the water on a hard surface clear of combustibles, using the supplied charger and never an extension cord. The receptacle must be GFCI protected, which is a code requirement for outlets near a pool rather than an option.
- Weekly: Clean the brush and the waterline contact surfaces to remove algae film and chemical residue.
- Every 3-6 months: Inspect the drive brushes for wear and replace them when they stop making consistent contact.
- Annually: Replace the filter media if flow has dropped or the material has degraded.
- Storage: Charge the pack before storing the machine for the season and keep it out of direct sun. Store it charged, not flat.
How much each of these is standing on.
Classifications rest on different depths of evidence. A pre-release assessment and a verified one are not the same kind of claim.
| Robot | Evidence status | Sources reviewed | Last assessed |
|---|---|---|---|
| Ecovacs Ultramarine P1 | Provisional | 8 | Sep 2026 |
| Wybot C1 | Provisional | 3 | Aug 2026 |
Add a robot
Comparing across classes is allowed — the page will switch to per-class positioning and tell you it has.