Skip to content
Saved

ComparisonHusqvarna Automower 115H

Up to three

All robot lawn mowers. Every figure below is placed against the whole class, so a gap can be read against how much the class itself varies.

Where each one suits you.

The conditions each robot was assessed against, side by side. Rows marked in gold are where these machines genuinely differ.

Fit verdicts by condition for each robot
Condition Automower 115H
Yard size
Under ¼ acre Good115H runtime covers sub-1,000 sqft yards in one pass; well-matched to compact lots.
¼ – ½ acre Depends1,000-2,000 sqft range is the 115H design target; 2,000 sqft edges the 60-minute runtime ceiling with one-pass coverage.
Over ½ acre Poor60-minute runtime does not cover yards over 2,500 sqft in one mowing cycle; multi-pass operation required.
Terrain
Mostly flat GoodOptimal operating condition; manufacturer specs and owner reports show consistent performance on level yards.
Gentle slopes DependsRated to 20% slope per manufacturer documentation; steeper grades may cause traction loss and uphill stalling.
Steep / hilly PoorManufacturer documentation does not support operation above 20% gradient; owner reports document traction failure on steeper terrain.
Grass type
Typical lawn grass GoodDesigned for typical cool-season and warm-season turf; perennial ryegrass, fescue, and Bermuda all perform within spec.
Mixed / tall growth DependsCutting deck height adjusts to 50 mm maximum; tall fescue and some native grasses may exceed cutting reach; multiple passes improve appearance.
Thick (Bermuda / Zoysia) DependsDense turf increases motor load and blade dulling frequency; weekly blade inspection recommended in high-density stands.
Boundary setup
Wireless required PoorBuried boundary wire is mandatory; no GPS or wireless boundary option available on the 115H.
Wire required GoodWire-based perimeter is the sole positioning method; perimeter installation (2-4 hours) is a standard prerequisite.
No preference GoodWire-guided operation works for any boundary preference; no wireless requirement complicates setup decision.

A robot being poor for a condition is a fact about fit, not a fault. “Depends” means the record names a limit worth reading, not that the answer is unknown.

Keep going.

Robovations classifies robots; it does not rank them. Nothing on this page is a recommendation, and no manufacturer influences a classification or its placement here.