Skip to content
Saved

ComparisonHayward AquaVac 650 and Maytronics Dolphin Liberty 600

Up to three

All robot pool cleaners. Every figure below is placed against the whole class, so a gap can be read against how much the class itself varies.

Where each one suits you.

The conditions each robot was assessed against, side by side. Rows marked in gold are where these machines genuinely differ.

Fit verdicts by condition for each robot
Condition Hayward AquaVac 650 Dolphin Liberty 600
Pool type
In-ground GoodDesigned for in-ground gunite/plaster pools; dock placement requires dedicated 110V outlet and 10-foot clearance. GoodDesigned exclusively for in-ground pools with perimeter access for dock placement.
Above-ground PoorBrush geometry and dock coupling target in-ground installations; vinyl walls not compatible with HexDrive pads. PoorNot designed for above-ground pools; dock stability and electrical exposure are concerns.
Mixed setup GoodStandard for this category, see specs for confirmation. GoodIn-ground pools only; confirm dock can be placed near pump or pool edge safely.
Pool size
Small (< 400 sqft) GoodCapable but overkill for pools under 8,000 gallons; smaller battery-powered units offer better cost alignment. GoodFull feature set (waterline + floor + wall) overkill for under 8,000 gallons; a smaller cordless model would be lower cost.
Medium (400 – 800) GoodIdeal target: 12k–18k gallons. Two-hour runtime covers a single session without battery strain. Good12,000–25,000 gallons is the designed envelope; one 90-minute cycle achieves full three-plane coverage.
Large (> 800) DependsConsecutive sessions required for 20k+ gallon pools; multiple cycles per week increase dock-seal wear patterns. Depends30,000+ gallon pools require 110+ minutes for three-plane coverage; two cycles or battery replacement mid-session recommended.
Debris load
Fine (sand / silt) GoodPleated intake filter handles silt and algae detritus effectively; weekly rinse prevents clogging. GoodFine sediment handled well; filter cartridge rinses easily after fine-sediment sessions.
Leaves / large debris Good18L debris bin covers heavy autumn load; daily empties typical in peak seasons. GoodBattery limits runtime in high-debris scenarios; pre-skim pool during fall to avoid basket clogs and runtime depletion.
Algae / heavy foulingthey differ DependsWaterline brush targets surface-film algae well; free-floating algae requires pre-filtration. GoodWaterline jet addresses algae at tile line; floor and wall coverage complete. Light biofilm handled in one pass.
Coverage you want
Floor onlythey differ DependsCapable but this robot targets floor + waterline; wall coverage requires manual intervention. GoodComplete floor coverage; floor-only mode available in app to conserve battery.
Floor + wallsthey differ PoorHexDrive geometry does not reach vertical walls; only floor and waterline are documented. GoodWall climbing and floor coverage integrated; wall-return engagement automatic.
Floor + walls + waterlinethey differ PoorWaterline reach is documented; wall coverage and suction line pathing are not autonomous. GoodWaterline jet is included; covers tile line in dedicated 15–25 minute cycle within full 90-minute runtime.

A robot being poor for a condition is a fact about fit, not a fault. “Depends” means the record names a limit worth reading, not that the answer is unknown.

Keep going.

Robovations classifies robots; it does not rank them. Nothing on this page is a recommendation, and no manufacturer influences a classification or its placement here.