A $1,700 Roborock vacuum skips carpet in one of its cleaning modes
Roborock’s Saros 20 Flow, a $1,700 robot vacuum, skips carpet entirely in one of its cleaning modes. Set to clean a specific zone, a review published November 15, 2026, found the robot swept and mopped the hard flooring but left the carpeted sections of that same zone untouched. Zone cleaning is a routine setup in […]

Roborock’s Saros 20 Flow, a $1,700 robot vacuum, skips carpet entirely in one of its cleaning modes. Set to clean a specific zone, a review published November 15, 2026, found the robot swept and mopped the hard flooring but left the carpeted sections of that same zone untouched.
Zone cleaning is a routine setup in homes with mixed flooring, so the bug would surface in ordinary use, not just a test.
The Flow trades the Saros 20’s spinning mop pads for a roller mop. The same review, of a single unit, asked Roborock to explain the carpet behavior; by publication the company had not answered. That unit also rolled over loose cables rather than avoiding them, sometimes dragging one across the floor, and spent close to 12 minutes finding its dock on one run.
Outside that mode the robot finished a 750-square-foot apartment in just over two hours with about half the battery left. The mop-drying fan afterward ran loud enough that the reviewer switched it to eco mode to quiet it.
A September review of the same model had already logged a different limit: crumbs near cabinetry the brushes could not reach. Roborock made no public change to the Flow between that review and this one.
Nothing published says whether the carpet skip is one bad unit, one firmware build, or the model itself; only that single machine was tested for it. That November review’s chief complaint was simpler than any bug: at $1,700, the price, next to competitors it judged similarly capable.
More than a month on, with no fix acknowledged in between, Roborock’s silence leaves open whether it treats the carpet skip as a defect or a built-in limit of that mode.







